This document has been reviewed as part of the transport area review team's ongoing effort to review key IETF documents. These comments were written primarily for the transport area directors, but are copied to the document's authors and WG to allow them to address any issues raised and also to the IETF discussion list for information. When done at the time of IETF Last Call, the authors should consider this review as part of the last-call comments they receive. Please always CC tsv-art@ietf.org if you reply to or forward this review. This review was requested in a very short period of time and I could not read all the Detnet related materials. I focus on issues that could be relevant for the transport area. The introduction indicates that the Detnet architecture supports IP and MPLS flows, but section 5.4.2 indicates that and IP flow can be specified using the following attributes : a. SourceIpAddress b. DestinationIpAddress c. IPv6FlowLabel d. Dscp (attribute) e. Protocol f. SourcePort g. DestinationPort h. IPSecSpi I would personally qualify the flows that include transport layer information as layer-4 and not IP flows. Maybe a note in the introduction should be mentioned. In the document, it is unclear to me whether some of these attributes are optional or can be specified as wild cards. Maybe this is described in another document. The information model defines various attributes. Some of the definitions are very precise and mention the measurement unit. For others, this is less clear. For example, intervals are defined in units of nanoseconds, but payloadsize is not defined as a number of bytes. Some information elements appear unclear to an external observer like me: 5.9.4. Maximum Loss of the DetNet Flow MaxLoss defines the maximum Packet Loss Ratio (PLR) requirement for the DetNet flow between the Ingress and Egress(es). There is no measurement interval define for the packet loss ratio. 5.9.6. Maximum Misordering Tolerance of the DetNet Flow The definition is unclear and does not make it easy to measure this value 6.3.1. Minimum Bandwidth of the DetNet Service From the definition, it is unclear to me whether the payload only is used to compute the bandwidth or whether this includes the headers and if so which I was surprised by the following paragraph 6.4. Connectivity Type of the DetNet Service Two connectivity types are distinguished: point-to-point (p2p) and point-to-multipoint (p2mp). Connectivity type p2mp is created by a transport layer function (e.g., p2mp LSP). (Note: mp2mp connectivity is a superposition of p2mp connections.) Does the note precludes the utilisation of multicast to support the detnet service ? If so, I don't think that this restriction should be part of an information model. It should be specified in an architecture document. 6.6. Rank of the DetNet Service The DnServiceRank attribute provides the rank of a service instance relative to other services in the DetNet domain. DnServiceRank (range: 0-255) is used by the network in case of network resource limitation scenarios. From this description I do not know whether a high value rank gets more resource than a low value one. I would suggest to clarify this in the definition of the rank.