Internet-Draft BFD Signal Degrade Indication December 2022
Han, et al. Expires 27 June 2023 [Page]
BFD Working Group
Intended Status:
Standards Track
L. Han
China Mobile
M. Wang
China Mobile
F. Yang
Huawei Technologies
R. Tan
Huawei Technologies

Signal Degrade Indication in BFD


To satisfy the requirements of signal degrade indication described in [I-D.yang-mpls-ps-sdi-sr], this document illustrates the extension of BFD protocol to support signal degrade indication.

Requirements Language

The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in RFC 2119 [RFC2119].

Status of This Memo

This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79.

Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet-Drafts is at

Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress."

This Internet-Draft will expire on 27 June 2023.

Table of Contents

1. Background

Signal Degrade (SD) is categorized as one of triggers to bring survivability challenge to networks [RFC4428]. Not like the signal failure caused by failure of links or nodes, Signal Degrade (SD) is normally caused by fiber aging, fiber impairment, fiber pollution, optical module mismatch or WDM transmission error etc.

The detection and transmission of signal degrade is discussed in [I-D.zhl-mpls-tp-sd] and [I-D.yang-mpls-ps-sdi-sr]. When signal degrade is detected, it can be spread via control plane, forwarding plane, or management plane, or combination of any of them.

BFD [RFC5880] and SBFD [RFC7880] are widely used as the failure notification in networks due to the characteristics of simplicity and efficiency. BFD also provides good opportunity to indicate signal degrade by reflecting it in BFD state changes. This document extends the BFD protocol to carry signal degrade indication in networks.

2. Terminology

SD: Signal Degrade

BER: Bit Error Rate

MIP: Maintenance Entity Group Intermediate Point

PLR: Packet Loss Rate

FEC: Forwarding Error Correction

SLA: Service Level Agreement

BFD: Bidirectional Forwarding Detection

SBFD: Seamless BFD

OAM: Operation, Administration and Maintenance

3. Signal Degrade Overview

3.1. Signal Degrade Definition

In [IEEE 802.3-2018], Bit Error Rate (BER) is defined as the ratio of the number of bits received in error to the total number of bits received. It is one of parameters to indicate quality of physical links. Depending on the Forwarding Error Correction (FEC) capability of PHYs, BER can be classified into pre-FEC BER and post-FEC BER. The pre-FEC BER value acquired from PHY on receiving port indicates the on wire BER value of physical link. This value can also be measured via external test instruments. Generally speaking, BER specifically refers to pre-FEC BER. If FEC capability is unavailable for some legacy PHYs, it is meaningless to differentiate pre-FEC and post-FEC BER values.

Signal degrade can be detected based on the physical bit error statistic on port level, no matter whether the PHY is with or without Forwarding Error Correction. Port level statistic is an intuitive approach to be best understood in the equipment and network systems. In practice, flexible configuration of the watermark to trigger the indication of signal degrade is also preferred.

3.2. Signal Degrade vs Packet Loss Rate

In packet switched network, the measurement of physical link is based on the unit of packet, resulting in either no packet loss or a number of packet loss to indicate the status of link. Although PHYs are defined in [IEEE 802.3-2018], vendors may have different implementations to deal with the error bits when equipment detects them. Moreover, bit is a fix unit, but packet has variable length. Several error bits can lead to one packet loss, or multiple packets' loss. There is no uniform approach to calculate pre-FEC BER into PLR. It means there is no parameter directly indicated the status of physical links in packet switched network.

3.3. Use BFD to Support Signal Degrade Indication

For the network where BFD is used to provide the fast failure detection, the minimal detection interval e.g. 3.3ms actually leaves a huge gap of data packets between two consecutive BFD packets when the line rate packets are transmitted over high speed Ethernet link. Take an example of 10Gbps link transmitting the packets with length of 192 bytes to calculate, more than twenty thousand packets are transmitted within 3.3ms. Note that the criteria to announce a failure of BFD based on three consecutive BFD packet loss. It may not be accurate to rely on BFD to detect and trigger the protection mechanism if there is signal degrade on the physical link.

3.4. Notification Spread in Network

In current packet switched networks, the error bit information like BER is only obtained and processed locally on each node. There is no indication or advertisement of the errors or its indications of physical links. It should be possible to spread this information via control plane, management plane or even data plane to suit for different needs. Especially, if the signal degrade of the link could be transmitted in data plane and aware by any other nodes, local repair or end-to-end path protection could be performed even more efficiently. Previous work proposed in [I-D.rkhd-mpls-tp-sd], [I-D.zhl-mpls-tp-sd] and [I-D.zhang-ccamp-rsvpte-ber-measure] give the examples of protocol extensions to support SD transmission for further network convergence behaviors. With the emerge of telemetry, it is also possible to collect and report this information more frequently to SDN controller to facilitate the network operation and management.

4. BFD Extension to Indicate Signal Degrade

The Diagnostic code in BFD specifies the local system's reason for the last change in session state. The definition of the Values is specified in Section 4.1 of [RFC5880].

In this document, reserved values from 9 to 31 are requested to IANA to support the signal degrade indication and removal.


       0                   1                   2                   3
       0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
      |Vers |  Diag   |Sta|P|F|C|A|D|M|  Detect Mult  |    Length     |
      |                       My Discriminator                        |
      |                      Your Discriminator                       |
      |                    Desired Min TX Interval                    |
      |                   Required Min RX Interval                    |
      |                 Required Min Echo RX Interval                 |
      |                   Authentication (optional)                   |

BFD Packet Format

5. IANA Considerations

The document requires the definition of the new indication and removal of the signal degrade indication in BFD Value code.

6. Security Considerations


7. References

7.1. Normative References

Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, , <>.
Katz, D. and D. Ward, "Bidirectional Forwarding Detection (BFD)", RFC 5880, DOI 10.17487/RFC5880, , <>.
Pignataro, C., Ward, D., Akiya, N., Bhatia, M., and S. Pallagatti, "Seamless Bidirectional Forwarding Detection (S-BFD)", RFC 7880, DOI 10.17487/RFC7880, , <>.

7.2. Informative References

Ram, R., Cohn, D., Daikoku, M., Yuxia, M., and Y. Jian, "SD detection and protection triggering in MPLS-TP", Work in Progress, Internet-Draft, draft-rkhd-mpls-tp-sd-03, , <>.
Yang, F., Han, L., and J. Zhao, "Problem Statement of Signal Degrade Indication for SR over MPLS", Work in Progress, Internet-Draft, draft-yang-mpls-ps-sdi-sr-01, , <>.
Li, Z., Zhang, L., and G. Yang, "RSVP-TE Extensions for Bit Error Rate (BER) Measurement", Work in Progress, Internet-Draft, draft-zhang-ccamp-rsvpte-ber-measure-02, , <>.
Haiyan, Z., Jia, H., and H. Li, "SD-Triggered Protection Switching in MPLS-TP", Work in Progress, Internet-Draft, draft-zhl-mpls-tp-sd-03, , <>.
Papadimitriou, D., Ed. and E. Mannie, Ed., "Analysis of Generalized Multi-Protocol Label Switching (GMPLS)-based Recovery Mechanisms (including Protection and Restoration)", RFC 4428, DOI 10.17487/RFC4428, , <>.
Bocci, M., Ed., Vigoureux, M., Ed., and S. Bryant, Ed., "MPLS Generic Associated Channel", RFC 5586, DOI 10.17487/RFC5586, , <>.
Sprecher, N., Ed. and A. Farrel, Ed., "MPLS Transport Profile (MPLS-TP) Survivability Framework", RFC 6372, DOI 10.17487/RFC6372, , <>.

Authors' Addresses

Liuyan Han
China Mobile
No.32 Xuanwumen west street
Beijing, 100053
Minxue Wang
China Mobile
No.32 Xuanwumen west street
Beijing, 100053
Fan Yang
Huawei Technologies
Huawei Campus, No. 156 Beiqing Rd.
Ren Tan
Huawei Technologies
Huawei Campus, No. 156 Beiqing Rd.