Hi, I have been selected as the Operational Directorate (opsdir) reviewer for this Internet-Draft. The Operational Directorate reviews all operational and management-related Internet-Drafts to ensure alignment with operational best practices and that adequate operational considerations are covered. A complete set of _"Guidelines for Considering Operations and Management in IETF Specifications"_ can be found at https://datatracker.ietf.org/doc/draft-ietf-opsawg-rfc5706bis/. While these comments are primarily for the Operations and Management Area Directors (Ops ADs), the authors should consider them alongside other feedback received. - Document: [draft-ietf-ccamp-flexe-yang-cm-11] - Reviewer: [Nabeel Cocker] - Review Date: [11-16-2026] - Intended Status: [Standards Track] --- ## Summary Choose one: - Has Issues: I have some minor concerns about this document that I think should be resolved before publication. ## General Operational Comments Alignment with RFC 5706bis This document defines a service provider targeted YANG data model for the configuration and management of FlexE, including FlexE groups and FlexE clients. It supports the configuration of FlexE client as an interface as the data model of FlexE client references the generic interfaces data model as defined in [RFC8343]. The issue I have is (and if this is addressed and I am missing it, please let me know), from an operators perspective, an operator has no way to check the configuration is working or to detect faults. Or that is not clear and explicitly explained and that applies to both remote and local state. In my opinion there needs to be more clarity on the fault management aspect, performance monitoring etc. (Again, if it is intrinsic to the YANG model described then an explanation would really be helpful). There is no Operational Considerations section. As this draft is targeted towards Operators, I see this as a requirement for this draft. (As required by RFC 5706bis). ## Nits - Section 1: "imbedded" -> "embedded"; "this document would only focus on" -> "this document focuses on". - Section 4, total-bandwidth and free-bandwidth: the examples ("such as 10" for total, "such as 100" for free) contradict each other, since free bandwidth cannot be greater than total. - Appendix A heading: "Appendix A. Appendix: FlexE configuration model illustration" repeats "Appendix". ---